Neato Botvac Main Brush Gear / Brush Drive
Print Profile(1)
Description
This part replaces the 6-sided gear that drives the brush of the NEATO Botvac D7.
In our model, the 6-sided connector was rounded.
Therefore, the wrench size (SW) of the component was increased from 11.5 to 11.7 mm. This ensures a better fit into the brushes.
These have a 12mm SW.
Furthermore, the SW was extended by 1 mm.
For the printed model:
Break off the support structure.
Widen the hole on the back with a 7mm drill bit (reverse rotation), then the print marks will be smoother and
the component will slide well onto the shaft.
Assembly:
For disassembly / assembly, only a TORX TX10 and a Phillips head screwdriver are needed to open the Botvac housing.
A small slotted screwdriver is advantageous for removing the battery; its cable is secured with a clip.
The drive including the motor is only plugged in.
7mm drill bit or preferably 7mm reamer (I did it with a drill bit, it works well. Not everyone probably has a reamer)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (6)