kotu the kakamora warrior（coconut） form moana2

缘由 Reason

陪孩子看《海洋奇缘2》，被里面的小椰子人卡图吸粉。义无反顾割断绳子救下族人简直太帅了。

没有从网上找到模型，就自己捏了一个。没想好吹箭应该怎么背就没有做。

打印出来用丙烯笔涂色，看着还可以。没有上色经验，纯属自娱自乐。

I was watching Moana 2 with my child and was charmed by the little coconut man Kato. His act of resolutely cutting the rope to save his tribespeople was just too cool.

I couldn't find a model online, so  I made one myself. I didn't figure out how to design the blowgun to be carried on his back, so I didn't make it.

After printing it out, I colored it with acrylic pens, and it looks pretty good. I have no experience in coloring, it's purely for my own amusement.

配置情况 Configuration Status

陆续打印了很多版，都成功了。最终调整为有机树支撑，支撑面略有粗糙但是可以接受。我陆续打印了超过十个，支撑比较好拆。

四层墙，让它更加结实，防止拆支撑的时候掰断腿。足底做了平整，可以自己站立在桌面上。

唯一需要注意的是拆面具侧面鱼骨的时候需要小心，特别容易断裂。如果真的断了请用胶水粘上。

使用的材料是PETG，但我相信PLA也能达到不错的效果。

I've printed several versions, all of which were successful. In the end, I adjusted to using organic tree supports. The support surfaces are slightly rough, but that's acceptable. I've printed over ten of them, and the supports are relatively easy to remove.

I used a four-layer wall to make it more sturdy and prevent the legs from breaking when removing the supports. The soles are made flat so that it can stand on its own on a desktop.

The only thing to pay attention to is that when removing the fishbone on the side of the mask, you need to be careful, as it's particularly prone to breaking. If it does break, just glue it back together.

The material I used is PETG, but I believe PLA can also achieve good results.