Monitor Vesa 100x100 Mount Creative Stage Air2
Print Profile(1)
Bill of Materials
- M5x25Bolt x 2:
Description
I can't find Creative Stage Air2 that can mount with vesa so i made it. I use PETG as my main filament but you can switch to pla or something else.
……………………
I use caliper and creative website picture to measure thing out and modeling it in Blender 4.3 with leaving a bit of space out but it'll be tight fit still, I also try to reduce filament waste by boolean some of the vesa pole but end up almost save nothing so i just leave it there .
------------
To install it you'll need 2 of M-5x25-30 either is fine ,I use M-5x25 Bolt with the stopper in the picture…. use electric screw or hand screw to screw it inand lock with stopper. It should be tight fit even without the stopper.
First you put the left/right bracket slide in place (will be tight) until it hit the rubber pad then stop. After that screw in the vesa pole into vesa100 bracket and then the hard part hold the sound bar and the pole and screw it in…..will need to do with patience without electric screw driver or someone to help you but end result was like in my picture.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)