Search models, users, collections, and posts
antenna 433 mhz
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 12% infill
Designer
10 min
1 plate
Open in Bambu Studio
Boost
3
8
0
1
5
1
Released
Description
a simply 10 minute print for make your antenna for a 433 mhz module for raspberry / arduino
the print is modelled for a 0.6mm cable but you can use a smaller one too, i used a 0.3mm
the length and the spires are calculated for 433mhz
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)