C25 Articulated Figure, Print-in-Place, Highly Posable

Enhanced articulation throughout; no need to forcefully unlock joints—pure print-in-place design. Rigorously tested; print with confidence.

Includes hand poses & an accessory pack. Knee joints may feel initially stiff.

Scale x1 & p1 models up by 15%; otherwise, multiple joints may become jammed. Currently seeking a solution to fully enable articulation on p1 and x1 models.

[Compared to the first generation, this model is 30g lighter and prints 1 hour and 23 minutes faster.] Swift articulation mitigates excessive tightness.

Should any issues arise, please comment; I will promptly address them.

PLA may result in excessive looseness. High-shrinkage filaments are recommended; PETG is suggested. Further scaling down is not advised unless using a 0.2mm nozzle.

To encourage derivative works, this model is not part of any exclusive model program.