Car Ramps Kit Card & single parts 1:24 accessories

Summary
This is a easy-to-print 1:24 scale model of car ramps in a kit card style. The single parts are also available.

Print
Print with 0.2 - 0.3mm layer height.
No supports are needed.
Use 3 perimeters - infill not needed.

Small print bed? Place it at an 45° angle on the print bed!

Dimensions at 100% scale (1:24)
Height: 22mm
Length: 71mm (short) & 200mm (long)
Width: 20mm

Scaling is possible completely and without any limitations.
Calculation formula using the example of target scale 1:18:
24 / [18] * 100 = 133% scale in your slicer

Other models
I will also try to publish other car related garage / diorama models. Stay tuned!

I hope you had as much fun printing and assembling it as I did :-)

Do you like my work? I would be very happy if you would support my work on Ko-fi.