Print In Place Magnetic Heart Locket Fidget Toy
Print Profile(2)
Bill of Materials
- Glue x 1:
Description
Boost Me (for free)
Boosting helps this model become more visible to other users and gives me more motivation to create more designs for you guys!
Commercial license for all my models -→ https://www.patreon.com/MeasureOnce
PLEASE READ BEFORE PRINTING
This project requires 10 4x2mm magnets.Please see the BOM for the link to makersupplies to purchase them. The joints should feel loose without the magnets. Once you install them, the magnets will stabilize the joints and the spinning improves significantly.
FOLLOW THE STEPS BELOW TO PROPERLY GET THE JOINTS FREE
STEP 1: After printing, wait 5-10 minutes for the plastic to cool down and fully harden before twisting. After 10 minutes. twist along the crease as shown in gif below.
STEP 2: MAKE SURE YOUR PART HAS COOLED BEFORE DOING THIS STEP. Keep the locket in the heart position and place your thumb on the bottom of the heart. Gently work free the 2nd joint by spinning the half about your thumb as shown in the gif below. Spin one direction for a little than the other. Once one side starts spinning freely, spin it a full 360.
STEP 3: Glue 10 4x2 magnets in the locations shown in the image below. Be mindful of their polarity.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (55)