Search models, users, collections, and posts
Zhao Yun's Dragon Spear - Optimized Spear Head and Tail, Practical and Durable Version
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 30% infill
Designer
4.7 h
1 plate
Open in Bambu Studio
Boost
85
155
5
4
96
37
Released
Description
Content has been automatically translated.
Zhao Yun's Dragon Spear - Optimized spear head and tail, practical and durable version. It is recommended to use a 20mm diameter, 3mm thick white water pipe for the spear shaft for optimal durability.
When printing, it is recommended to use PLA+, with a layer height of 0.2mm. When using a layer height of 0.2mm, set the overhang speed to four levels: 60/40/25/10. Set the full overhang wall speed to 20mm/s, and the bridging speed to 20mm/s as well.
Use 3 walls, concentric pattern for top and bottom surfaces and infill. Use a honeycomb pattern for 30% infill.
With these settings, supports are completely unnecessary, saving you...
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)