The Best RC Control Horn! - Free 3D Print Model

Search models, users, collections, and posts

MissionUAV

Hobby & DIY>RC

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.16mm layer, 3 walls, 20% infill

Designer

15 min

1 plate

4.7(17)

Open in Bambu Studio

Boost

139

354

260

Released

Description

This here is the control horn I use for all of my RC models! I print in ASA for better layer adhesion, but PLA or PETG will work too. So far, these little guys have held up great! There are troughs on the bottom surface for better glue adhesion. They print fine without supports.
The generous fillets prevent the arm from snapping off its base.
The holes fit 1.19mm wire just fine. Snug, but not too much.

Happy Flying!

control

servo

strong

Comment & Rating (19)

@user_770125903

Print Profile

0.16mm layer, 3 walls, 20% infill

its nice strong, pretty neat!

@dieggs

Print Profile

0.16mm layer, 3 walls, 20% infill

perfetti

@cassius_horvath

Print Profile

0.16mm layer, 3 walls, 20% infill

Very nice!

@PilotDudeOG

Boosted

This helped out a lot during a RC plane project I was making, and I relised I didn't have any control horns.

@user_3122266967

Print Profile

0.16mm layer, 3 walls, 20% infill

my feeling on this is its strength is purely based on layer adhesion. decided not to employ it

@gideonreimer

Print Profile

0.16mm layer, 3 walls, 20% infill

very good model works good for me so far I just feel a little sketchy if it will stay on with out a peg going into the wing surface. would recommend using.