Search models, users, collections, and posts
Metmo Cube Stand
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
1.2 h
1 plate
Shorter variants - 0.2mm layer, 6 walls, 25% infill
Designer
1.7 h
1 plate
Open in Bambu Studio
Boost
4
5
1
0
14
6
Released
Description
Full props go to @chanik21 on thingieverse.
I just wanted to share my 3mf with orientation, strength and supports I used with good results.
WARNING: Be sure to gently flip the cube AND stand as one! The clearance is so precise, the pistons WILL fall out if you try to flip it without the stand. I would not advise leaving the cube inverted at idle. If i math that correctly it equals ‘ehhhh?’
Be careful!
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (1)