Search models, users, collections, and posts
layerneer bed weld multiboard mount
Remixed by
IP Report
Print Profile(3)
0.2mm layer, 5 walls, 15% infill
Designer
1.6 h
1 plate
44mm size 0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
44.5mm 0.2mm layer, 4 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
3
9
12
1
23
13
Released
Description
was looking around and notice no one had a mount for layerneer bed weld glue so i deiced to whip one up real quick. print settings are the same as multiboard just changed the walls to 5 instead of 3. there is two new models that i made a bit bigger id measure your bottle to make sure it works for you before printing. The original model will look different as i made the new ones in fusion and old one was made in tinkercad
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (12)