Mechanical Wolfman
Print Profile(1)
Description
Prototype Mechanical Wolfman
As this is a prototype model used to verify the structure and shape, there is basically no internal detail depiction. It is recommended that the armor be glued on after assembly.
The overall height is approximately 18cm, and the joints are articulated.
Glue the shoulder and chest connection.
The lengths of the pins differ: the shortest is for the elbow joint connection, the longest for the thigh and knee joint connection, and the medium length for the lower leg and knee joint connection.
Due to different armor interfaces, the arms must be distinguished as left and right. Please confirm before inserting the elbow joint pin.
The knee connectors are top and bottom. Attach the decorative parts after ensuring they do not impede the range of motion.
The image on the right shows an incorrect top-bottom installation, interfering with the range of motion.
Currently only PLA material is used for printing; other materials have not yet been tested. The waist ball joint uses a zero-tolerance design, but is still somewhat loose; please reinforce as needed. For other loose joints, use a joint reinforcement pen or paper towel to increase friction.
Use textured plates and apply glue to maximize the print success rate.
Due to the parts separation, the armor has sharp edges; exercise caution when removing supports.
Arm and leg part diagrams are shown below:
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)