Cigarette Filter Tip Boxes

Since I was annoyed by always carrying a full bag of those cigarette filter tips with me but I also do not like having them loose in my tobacco or pockets, I created those small slide out boxes to store them.

These boxes fit the standard 6mm cigarette filter tips.

There are 4 Versions:

• 30 Tips with a notch to see where the top is
• 21 Tips with “FILTERS” lettering to see where the top is
• 20 Tips with a notch to see where the top is
• 14 Tips with “FILTERS” lettering to see where the top is

The tray can be pushed out from the back of the box.

It has a small notch at the front that clicks in to hold it in place when closed.

It can also be pulled out completely and turned around to better get to the filters in the back.

The filters will not fall out when held upside down in the open tray.

I printed those with (translucient) PETG for the trays and PLA for the sleeves.

Depending on the dimensional accuracy of your printer, you may need to file the two notches in the sleeve a little bit to make them close/open more easily.