Search models, users, collections, and posts
Ender 5 Plus C910 Mount
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
34 min
1 plate
Open in Bambu Studio
Boost
2
7
0
0
9
1
Released
Description
I was using the original model this was remixed off of, but when I installed an LED mount it ended up being too tall and in the way. Model was modified to slightly go around the bottom of the 42-40 motor for a more secure fit, and lowered height for the C910 webcam to go under the LED bar.
The third photo shows a comparison of the old model to this one (beige original, white this remix).
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)