Pegboard Blank

This is a pegboard “blank” for making your own pegboard modules. Simply use your favorite editing program to add these to boxes, hooks, clips, rings, or anything else that you want to hang on a pegboard. The pegs are already measured out and shaped to fit seven consecutive holes - although most projects will not need all of the pegs. Use negative spaces, un-fills, or holes to erase the extra pegs. They are already measured and tested and work with all ¼-inch American pegboards. They will not work with SKADIS boards, and may not work with some European peg boards as the measurements are slightly different.

You can also print this out by itself and simply glue it to an existing object to hang it on a pegboard. If you do this, I recommend laying it with the large flat side down so you don't need supports. Upright positions (like the one it is saved in) will need some supports for the hooks and pegs. Tree supports are best, and .5mm gap spacing between support and object to help remove the supports easier and cleaner.

Any type of filament works. I originally made these with the boxes already to get rid of a lot of extra PLA (I needed the spool for other things). Then I cut it down to make this blank for others to use. I made an 8" by 12" bin and only used three pegs total, and it works just fine. You can also use this to make bigger “blanks” by copying and overlapping until the pegs line up on top of each other.