Cheetara

Cheetara

The nostalgia trip continues with Cheetara, in her iconic colours, wealding her staff, shes an imposing feline warrior.

Items are seperated for easier printing. AMS only needed for the eyes and logo, seperate profile for no ams at all. Roughly 26cm tall when complete.

Hair spots were drawn on with a sharpie, I could have cut them out and made a whole thing of it, but they would have been small and complicated to install, the arm is already trial enough! 

Instructions for arm spots are below:

Ensure you remove from the plate and remember the orientation from left to right. (number 6 has small supports - which helps distinguish the orientation)

Full colour models do produce a fair amount of waste due to significant detail and colour changes, so be aware before printing, the time is largeley due to colour changes and not the size of the model.

📌 Recommended printing settings:

• Material: PLA
• Layer height: 0.16 mm
• Infill: 15%
• Nozzle: 0.4mm
• Fuzzy skin for orange parts where it does not connect to the main body (already painted in profile)

supports where nessesary - I have tried to make it so all have a surface contacting the plate however due to the detail and complexity of the modeling they sometimes require alot of support, so be aware and be carefull during support removal. Use a naked flame gentley and for short intervals to clean surfaces after removal

Assembly – Recommended Method on multipart models

• Dry fit: Assemble all parts without glue to check alignment and fit.
• Cleanup: Lightly deburr edges and pegs where nessesary with a file/modeling tool to ensure uniform contact. All parts are tested and fit together.
• Optional fix: Use glue for permanent assembly.

NOT AI, NO AI COLOUR PICS WHICH DISGUISE A POOR DETAILED SINGLE COLOUR PRINT. REAL PRINTED RESULTS!

MOST OF MY MODELS ARE FAN ART RECREATIONS AND ARE FOR PERSONAL USE ONLY  : MY MODELS ARE UNOFFICIAL FAN ART AND ARE NOT AFFILIATED OR ENDORSED BY THIRD PARTY IP HOLDERS

Thankyou to everyone who has rated and boosted my prints, if you like the models and want to continue to support the creation of more please consider boosting, it really does help incentivise the creation of more models for makerworld. 

If you would like to "buy me a coffee" to support the continued creation of fun prints you can do so here;

All of my models posted here are free for you to use commercially for free. I make them as a hobby and a bit of fun, with the points helping supply filament and consumables. All i ask if you wish to support my designs and want to sell them is that you are aware of the IP infringement which apply to some of the models and take appropriate responsibility. Please also boost them as much as you can and help with the points and please correctly attribute the model design to this page in your descriptions etc - Thankyou again everyone!