Luci the devil

15 cm high. A base can be printed for it but it also stands on its feet. The pictures show a painted version. This involves significant work but is worth the effort.

Painting process:
- Completely removing the supports. Quite a difficult task because it is complicated. Be patient and pay attention to the small details and tail.
- Sanding. The PLA material can be sanded and painted well. Use about 240 wet sandpaper. In this case, you do not need to wet it, just use on dry. Sand all surfaces and details until smooth. Be patient and take your time. You do not need to be ultra perfect because the primer will also fill in many defects.
- Priming. After sanding, dust it off, I also wiped it with IPA. Use a filling primer spray. Only apply a thin layer at a time even if the result is very attractive. Leave a little drying time between layers until it becomes matte. My model was primed 3 times in thin layers. Wait for it to dry completely.
- Wet sand with 400 grit paper. Sand all surfaces thoroughly until you are satisfied with the surface. After sanding, remove dust. I also wiped it with IPA. If necessary, repeat the priming and sand again.
- The well-prepared model is now ready to paint. Use glossy black acrylic spray paint. Apply only thin layers at a time. Wait 3-5 minutes between coats. My model was painted in 4 layers. Do not paint thickly as it may skin or run.