Pikascrew

I needed an M8 wingscrew for a project for my kiddo, but wingscrews are boring. Obviously, the only solution was to overcomplicate it in a way that I could use a pun.

This is printed as objects to:

• Minimise support
• Make prettier surfaces
• Improve strength
• Reduce waste if printing in multiple colours

I have included plates so you can print 1, 2, or 4 pikascrews at a time. If you want to print without AMS: print one object, change filament, print the next object, and so on.

This file uses the same filament for the screwcaps and the threaded part - but in the picture I've used silver ABS for the threaded part.

Suggersed Assembly:

1. Put the red insert into the black outline - have it sitting level with the top edge.
2. Push the black outline onto the screwcap - starting on the side with the lower section (the red insert must line up with the lower section)
   This bit is pretty tricky because it's a tight fit - this was on purpose to avoid the need for glue while fiddling things into place.
3. Push the red insert to the bottom of its slot.
4. Add a few spots of superglue inside the cutout on the bottom of the screw cap.
5. Push the wings into the screwcap, then the threaded part.
6. Pikascrew it into something.