Glitch Bar

Do not use when shooting it can explode of the force from the stick flexing!

Glitch Bar is a floorball training tool for faster development of strength in arms and hands during dribbling.

Made for using when training dribbling and i strongly recommend to not use when shooting since the force from the stick flexing can break it into flying pieces! If one even thinks of shooting with this one need to use a TPU strap or velcro strap to keep it attached to the stick.

If only dribbling velcro or TPU strap isn't really necessary. 

Base weight (printed weight) depends on filament and setting but it is about 40g.

It is possible to add 10gx6 or 5gx12 or 4pc M12 nuts for a added weight of 60g.

it is designed for using regular wheel balancing weights so they are easy to find on amazon or car part stores.

if using nuts please check from time to time that they are not moving out of the Glitch Bar. i would recommend using some adhesive tape or gluing them in.

If using velcro or TPU strap you can fit a 15mm wide and 1.4mm thick strap through the retaining whole added to keep the strap from sliding up or down. 

For optional grip to the stick print the version with inset in the backside and add stripp of butyl tape or other more sticky material.

if inset not used it is better to print version without inset så that the whole back side is in contact with the stick.

The TPU straps i used needs to be forced in the whole but it is possible. https://makerworld.com/en/models/1012393-tpu-strap#profileId-991974

I have printed them in TPU A95.

Example weights on amazon.se

https://www.amazon.se/dp/B08T1TWG5R

https://www.amazon.se/dp/B01M4M7DJ6

Note i just cut close around the sides of the weights.

Example velcro double sided velcro on aliexpress

https://www.aliexpress.com/item/1005005392210702.htm

Example single sided velcro on aliexpress

https://www.aliexpress.com/item/1005006327643825.html

Note that it is a bit wide but if you just trim the edges to get it through the slit in the ring it works and is stronger than the double sided velcro.

# Notes

• If one want to use for shooting I recommend my other model https://makerworld.com/en/models/2400605-glitch-ring that is safer for this.
• Should be printed on an angel otherwise it will break easily from the force from the stick.
• I have tested printing with Both Bambu Lab Transparent PETG and Bambu Yellow PETG but i had problem with the bottom part of the print getting to hot in places and warping where the part is only walls and no infill using the standard bambu settings for these filament.