Side Table Remote Holder Mount
Print Profile(1)
Description
This is a remote stand mount that screws in on the underside of the table top. Allowing a seamless mounting experience. I personally do not care if I screw into the bottom side of the table, but you can always use mounting tape as well and get similar results. I have designed this mount to fit a variety of remotes.
Printed in PLA, but nearly any sturdy filament should do the trick.
My Mounting Scenario
Screws I used were 4mm in diameter and about 16mm in length. The mounting holes have a stand off of 7mm (Table top thickness was 19mm).
Remote slot sizes
First 2 remote slots: 25mmx40mm
Third remote slot: 25mmx60mm
These slots should be good for most modern and possibly universal remote controls in a living room setting. Please check your own measurements before printing.
Thank you and feel free to comment with any suggestions or requests for future models I can create!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)