Search models, users, collections, and posts
Industrial Controller Holder
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
4.6 h
3 plates
M3 Hardware Version 0.2mm layer, 3 walls, 15% infill
Designer
4.6 h
3 plates
Open in Bambu Studio
Boost
15
28
6
0
17
7
Released
Bill of Materials
Description
Industrial Controller Holder - my take on an industrial design inspired holder mount for a controller. Easy to print and assemble, this controller holder will make a nice addition to your gaming setup!
[Update: New print profile added for the same model but uses M3 hardware instead of M4.]
Features:
- Easy to print parts, minimal supports
- Mix and match colors to the style of your gaming station
- Simple design for ease of assembly
- Strong enough for most controllers (PLA at minimum works very well)
- Fits Xbox, PS, Steam, other controller sizes.
- If needed, the width of the Beam Brace could be scaled up or down to fit any misc. controller sizes.
Parts needed:
- 3D Print files (one each)
- M4 x 10mm Socket Head Screws (8x)
- M4 Hex Nuts (8x)
Assembly:
(Do the same for other side)
Feel free to leave suggestions or show off your own Industrial Controller Holder!
Enjoy!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)