Search models, users, collections, and posts
BoneBag Modifications
Remixed by
Print Profile(1)
Modifications that include TPU bottom, PCTG Clips, TPC pegs
Designer
35.8 h
8 plates
Open in Bambu Studio
Boost
46
143
2
2
66
17
Released
Description
- I've added a slot for a TPU bottom; for grip and so that it sounds less plasticy when placed on a hard surface. It fits pretty tight but would likely be best with some glue. I use Elegoo TPU 95a White.
- We were having all kinds of issues with the clips on the main bag breaking, especially since my wife loves printing the bag in Bambu PLA Matte Bone. I've replaced the clips on the main bag with removable ones, that can be printed in a stronger filament. I've been printing them in 3DFuel PCTG though they won't be seriously strong unless you print them lying horizontal, but I had issues with it not fitting the holes. But maybe if you play with the scale it would make up for that. When printed upside down, they actually stay in pretty well without glue, but if you like I've included a hole through the slot and clip. You can either use a screw or I just stick some unused filament in and cut it to fit. It doesn't require much just to stay in place.
- I've also included some peg holes in the handle bones. You can print out the included pegs. I've printed them in Elegoo TPU 95a White. It offers just a little bit of tension for keeping the shoulder bones in closed and in place. Though it's not perfected yet. So far I've been only using one peg per latch. But if you wanted to play with the Z scale you you could do one for each hole, when flatted just right. You may want to glue those in though. I may be back with a better solution.
Elegoo TPU 95a White
Bambu PLA Matte Bone
3DFuel PCTG Desert Tan
- I also found this awesome solution for a TPU strap.
https://makerworld.com/en/models/1660873-tpu-handbag-strap#profileId-1756954
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)