Retro Computer Wall Mount

Summary

I have had a couple of old home computers living in a box in a closet for more years than I care to admit. I decided that I wanted to display them. I really couldn't find anything that would work for what I had, so I came up with this. I wanted something versatile and easy to print. My hope is that this will work for most old computers such as the Sinclair 1000, Amiga 600/1200, Commodore 64/128, and Atari XL and ST series. I am including a STEP file for easy adjustment to fit your needs.

I am using this to display my Amiga 500 and my TI-99 4/a. It is a single file, so obviously print two to hang a computer. I was able to print a pair in a little over 3 hours at 0.2mm and 20% infill.

Print Settings                                            

Resolution:                      

0.2

Infill:                      

20%

Filament: PETG 
                        

Notes:                     

Set to have four walls for strength. I use PETG for all mounts I print, but this should work fine with PLA.