number 75

The rods measure 250mm in length and 2.5mm in height/width. Each number is approximately 150mm high and 100mm wide; the depth is about 2mm, plus a 5mm mount; refer to the image. I used green Bambu PLA filament. The print bed temperature was set to 70°C, and the nozzle on my A1 was set to 240°C; otherwise, the mounts wouldn't adhere. I recommend printing the mounts on a separate print plate to avoid the issues I encountered. Good luck, and please feel free to ask if you have any questions—I may be able to assist.

The rods are 250mm long and 2.5mm high/wide. A number is approximately 150mm high and 100mm wide, the depth is about 2mm plus a holder of 5mm, see picture. I printed with PLA bambu green. The print bed was set to 70°C and the nozzle of my A1 to 240°C, otherwise the holders wouldn't hold. I would recommend printing the holders on a separate print plate, as I always had problems otherwise. Good luck, and if you have questions, feel free to ask; maybe I can help you.