Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.9 h
2 plates
Open in Bambu Studio
Boost
58
146
14
6
113
61
Released
Description
!! Remove the purge line at the beginning of printing !!
This is a Lightbox with the logo from Atari.
The profile works OK with my settings but you must check and dial in your Printer accordingly.
there is a hole on the back side to hang the Lightbox and a hole on the side for a USB-C adaptor …
If you don't want to use the USB adaptor i have also included a small cap with a 4mm hole just to fit your cable in and another cap without a hole if you want to use a battery pack in it.
Enjoy !
USB-C Adaptor :https://s.click.aliexpress.com/e/_DBngla9
LEDs : https://s.click.aliexpress.com/e/_c4tQpZrz
Filament : https://s.click.aliexpress.com/e/_oEZjZ0d
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (14)