Search models, users, collections, and posts
Physics Track Coupler
IP Report
Print Profile(1)
Coupler x2: 0.2mm layer, 2 walls, 15% infill
57 min
1 plate
Open in Bambu Studio
Boost
4
11
0
0
8
3
Released
Description
This is a simple track coupler, which I use for my PASCO brand tracks. I use one on each side, with 4 - ¼ inch square nuts and 4 - ¼ by ½ hex bolts to secure them to the tracks.
I recommend printing these with a high infill for strength. I did not print with supports and they seemed to come out fine.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)