Search models, users, collections, and posts
Hive Hub Mount
Remixed by
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
17
53
14
4
115
99
Released
Description
A remix of a mounting bracket for a Hive Hub Nano 2, for wall or under desk use. Modification to remove a section of the bracket to allow for insertion/removal without needing to disconnect cables.
As per original design, can be secured with screws or 3M mounting tape. Model allows for a gap all round the hub, so there is some movement - suggest shrinking / scaling down a few mm in the slicer if you prefer a tighter fit. Prints just fine in PLA.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (14)