Search models, users, collections, and posts
Magnetic cable guide
IP Report
Print Profile(2)
v2 0.05mm tolerance
Designer
54 min
3 plates
v3 0.1mm tolerance
Designer
55 min
3 plates
Open in Bambu Studio
Boost
271
772
49
11
494
341
Released
Description
Magnetic/screw clamp/holder/guide for wires/cables etc for light weight application
- Attach using magnets or screw
- Fits a magnet of 6mm diameter and 3mm height
- Three different magnet tolerances (print profiles):
- v2 0.05mm. Snug fit (Recommended)
- v3 0.1mm. Just fits (Might need to be glued down)
- Three different sizes (Plates).
- Enable brim if you have bed adhesion issues.
Tiny
The overall diameter is about 12mm
Fits a cable/wire etc of ~4mm
Filament usage: 1.32g
Print time: 15mins on P1S
Small
The overall diameter is about 12mm
Fits a cable/wire etc of ~4mm
Filament usage: 1.64g
Print time: 18mins on P1S
Large
The overall diameter is about 14mm
Fits a cable/wire etc of ~7mm
Filament usage: 2g
Print time: 18mins on P1S
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (49)