Fit the Kirkland jug perfectly

Also used it to learn how to add text. I like how it turned out.

Also fits the handle for the top glass on the P2S

Tried printing with ASA, the lids didn't turn it so well - strings & bed detached so going to redry & retry.

Printed with ASA, they hold the filament and stay in the spool. One problem is that it doesn't allow a near full spool turn if you need to run a drying cycle and another is they do loose elasticity but maybe that's an ASA thing?

Very simple and Installs with ease.

Printed with ASA. Maybe a little on the lightweight side as the "springy filament clips" I have are able to push the sides out a little when in use. Not enough stop the spool from turning while drying so I don't think it's a big deal.

Exactly as pictured, just what I was looking for.

Perfect fit for my cereal boxes & hygrometers

Printed fine. Was able to cut/paste the smooth rod cleaner onto same plate & print both at the same time. I'd recommend an included option to print both but it wasn't difficult, even for a newbie like me.

Printed perfectly & fits in the Bambu spool, exactly what I wanted.

Printed perfectly but the upper vertical edge is just a tad inside the chute. It's not enough to stop any poop from dropping but I would prefer it be flush or a little outside the chute. I can probably heat it with a torch or heatgun & bend it out but I'm too busy playing with my new toy yet. For the removable tray, I would also put in a recess or two for a couple more magnets.

Made it with PLA with default settings & had a couple of slices stick together. I separated them with a knife & it works fine. Sliding is a little noisy (IMO) from the ridges rubbing, but that gives me a reason to try again & play with the settings right?