Print Profile printed great and supports came off easily. My only issue is that my Apple 240W USB-C to USB-C 2 meter cable didn't quite fit. It was a little too short. I've printed both the 19 and 21.5mm versions. Both were about the same amount short. Not sure what went wrong. Did I need to compress the organizer when I round the cable onto it?

Print Profile printed great and supports came off easily. My only issue is that my Apple 240W USB-C to USB-C 2 meter cable didn't quite fit. It was a little too short. I've printed both the 19 and 21.5mm versions. Both were about the same amount short. Not sure what went wrong. Did I need to compress the organizer when I round the cable onto it?

Took a little bit of force to allow the clip to close freely. Other than that great print and profile worked will on my A1

These work great for me. Printed in PLA.

I was successful. I was able to remove the supports. Thanks for the reminder of being careful on the leaves on the stem. This was the first print that I printed that used supports.