Search models, users, collections, and posts
Bio
....
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Very good, I decided to make it a little bigger so I could put two supports together, but if you make one, try putting some support inside because the "bridge" ends up being very long. I forgot and it got slightly deformed, but nothing too serious to the point of ruining the print.
Share
0
0
0
Share
0
0
0
Very good, although it has some small twisted angles but I don't know if it was my mistake
Share
0
0
0
Very good, it fit perfectly, the only change I made was in the top surface pattern I put hilbert to leave it with a better finish
Share
0
0
0
No more data