fits great in the camera, but would be a bit easier to use if the head was a little bigger or more like a narrow rectangle (easier purchase, won't hurt fingers).

Fits perfectly, allows easy access to the printer head for quick maintenance or clearing blockages

These fit 6.2mm (ID) arrows too, and fly dead straight. Tested out to 50m with great results! (photo is of 40m, first 6 shots with the TPU fletches. Shot from a compound bow, but shooting Barebow - no sights, finger release.They're a bit low because I was working out my settings... ) lots of interest from other archers at my club, looking for fletches to fit 4.2mm arrows. At 3g per set, I can't see myself using anything else!

just needed one of the spanners to tighten a nut on a drone headset - and it's spot on!

Great size, leaves the right amount of room for serving the string. Great for my old beast that I use for Compound Barebow shooting.

printed for a 0.05" (approx 1.25mm) Allen key for an archery tool. Fit was a little challenging (probably because the key wasn't truly 90 degrees) but with some manipulation it pressed in ok. Great profile!

Works like a charm! Hot tip: don't suddenly slow or stop the drill when the donor spool is on a roller with good bearings - momentum can be a b*tch! 😳

Spot on for holding champagne flutes and even smaller, narrow glasses (such as the limoncello glass in the photo). The inclusion of the little circular brims on each corner to avoid lifting during printing was genius!

Scaled to 97% fits a Yeti colster perfectly!

Printed off 2 to hang a recurve bow (2.5kg). Brilliant!

Great model, works brilliantly.

Printed perfectly first time. I did use a second rubber band to hold the seam of the lid tighter. Only 1 rubber band operates the lid.

works great! Hot tip: if you're planning on using this on a Yeti colster, scale it to 97% and it will fit perfectly.

Use PLA for the bottom, and PETG for the top (didn't have white PLA 😎) and it worked flawlessly for both materials. Got a mix of water and vinegar but no flies yet...

brilliant idea, can't wait to put it in action on NYE!