Very handy, cleans up all the remotes for the monitor lights, keyboard lights, ceiling aurora projector, etc.

These are great for my rechargeable 18650's.,,,.printed one in red for discharged batteries and one in green for fully charged batteries. Note: if you use Panasonic protected cell 18650's they are a fraction of a millimeter thicker than regular unprotected cells, so it's a VERY tight squeeze getting them in these holders. Just an additional quarter millimeter of hole size and they'd drop right in (the thickness of the extra wrap on a protected cell)

Great for Halloween and uses very little filament. I can now put bugs ALL OVER THE PLACE this Holiday! :)

ALMOST big enough for a brand new scotch tape roll. Inside diameter is perfect but could use an additional 1-2mm of relief on the inside for the size of a new, full roll of tape. Mine fit very tightly. (3M brand Scoth Magic greener tape 3/4"x 900in (25yd), 19mmx22,8m) Once a few pieces were pulled off the new roll, there was no more friction with the outer part of the holder.

Printed one standard size for my computer desk to hold all the miscellaneous charging cables, and printed one enlarged roughly 300% for work so the clerks would have a place to put the power cords instead of in my parcel bin. lol

Fits my glsss and metal salt/pepper shakers perfectly. Nice to have some organization.

Finally I can stop using all my shims for this. lol

scaled up to hold broken mailbox doors open when it's windy.

using this for pens and stuff in my delivery truck.

Resized for my cooler. Keeps the water bottles from sliding around and keeps my medicine and electrolyte power safe.

scaled them to fit the E track in my delivery truck, to hold my grabber pole....it's a hooked pole that I can use to slide stuff from the back of the cargo area to the front without having to climb up into the truck, difficult to do right now with two hernias. I glued a small block to the bottom to stabilize it.

Made two big and two small for various utility items in my delivery truck. PLA didn't last long in the heat, reprinted with PETG and it's holding up.

Scaled them up about 30% to use as dividers for return mail in my delivery truck. Finally have that mess cleaned up!

I needed caps for my salt and pepper shakers. I hate just having them open all the time. Resized to 42mm OD and 18mm H (print came out at 41.9) and they fit perfectly on these glass shakers from Walmart.

very useful for the workbench cleaning, and getting under the cabinets