my wife is, as I like to tell people, a mail escort. she found these, I printed them and she uses them daily!

no more shrinkage and lifting off the plate!

so glad I found this. love my surface pro, but getting it to sit vertical enough and not be unstable was impossible until now.

Very happy with it. some parts fit tighter than others. the only one that needed a reprint was the pins for the drawer handles. I upscaled them by 5% and re printed. I also notice the right drawer is a tad loose and seems to hang up a bit so I may add some glue there. I saw some reviews about adhesions issues. I too had an adhesion issue (not my first time) but upon further research I ended up printing a diffuser for the fan and haven’t had any issues since. poor design on the p2s not a fault of the print.