fits and works great

definitely do not print this in petg if you want to dry desiccant at 70°. almost found that out the hard way. 65° and it would’ve probably been fine.

good model and printed good but would not advise doing multiple colors. big waste of filament.

Printed in petg with a tpu gasket. came out great

Fits the LED remote I got for my riser perfectly.

Some fiddling got it to work. The bolt sheared off inside the nut on my first try, it was too tight and bound up too much. Ended up printing those again but I cut the bolt in half lengthwise and printed it flat then superglued the two halves together so the layer lines made it stronger. I also printed the bolt and the little hex key at 99% scale and I still had to sand down the thread of the bolt and the nut to get it to fit well. Put some paste wax on the threads and everything worked after all that. As another here said, I’m not running a print farm so I didn’t need a battery/motor powered one. Just needed a basic one for when I screw up a spool or when one is tangled.

Ended up breaking the handle part while removing supports on one side but it still looks like a coffee cup so we just have that side as a happy little accident facing the wall.

Works very well right off the printer. Posted it to Reddit so hopefully you got a bunch of likes and downloads.

printed with no problems. doesn’t really rewind the bags very well though. maybe it’s my bags.

turned out great. printed with pla but had to slow down the initial layer and wall speeds to 30mms, up the bed temp to 65°c, and increase initial layer and wall thickness to 0.28mm

fits perfect

printed the inner box for sleeveless cards at 99% scale to make it fit better.m, fit cards perfect and slide right into place itself.