modified slightly for my desires. but a good design

its good, I added a magnetized lid and some ridges to hold it in place while closed to the bottom box.

perfect fit

amazing model, great print.

the supports could be tweaked. I tore the threaded section off trying to remove them. nothing a bit of CA glue couldnt fix. Great model/print otheremwise.

added a thumb screw adaptor for the blade retention screw. but overall a great print.

bottom legs needed brim to stay on the plate but otherwise good print

exactly what I needed for a cosplay project. Modded the haft a little. and made a 4 point version as well.

excellent detail, shrank it down a bit as I wanted to use it as a bit of decorative filligree on a prop. still came out really nice, even smushed.

It would be better if the pieces keyed into each other instead of the flat butt joins, but it was still pretty easy to assemble.

works and easily scalable

I especially like the magnet on the slider that keeps it in place over the chosen side.

given P1S setting, the holes had to be cleaned up a bit.

Cool print, modded the plates that cover the joint as I wanted an Arasaka logo for a Cyberpunk Red game.

Printed perfectly, amazing model. I only wish there was a version with Zhang Fei's classic wavy serpent tongue blade. I took 1"/25mm poplar dowel and 1" sched 40 pvc to make the haft. I used the split bladed version. It all fits together so snug glue is almost redundant.

works perfecrly.

great easy print, works great.

easy print, lots of fun, printed for my wife, she digs it.

my daughter is quite enamored with it.