Search models, users, collections, and posts
Bio
working in IT, having fun printing, trying my best at designing
Achievements
MakerWorld Guardian
Active more than 20 days out of last 30 days UTC time
Die Klappe ist immer wieder dann zugefallen wenn man es am wenigsten gebrauchen konnte (mit einem vollen Behälter beim Auffüllen), daher hab ich den Halter designed um dem ein für alle mal ein Ende zu setzen.
Ford washer fluid lid holder
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
Share
0
0
0
works fine with the small stick for the smaller bladders (like the Moskau moto branded bag)
Share
0
0
0
Printed in TPU for bending the vacuum along the wall behind closets. Came out nice and fits perfect, some dents on the top end right corner (1cm), looks like a moving/ flexing part as it increases with height.
Share
0
0
0
fit for the initial twist is a little bit tight but works fine
Share
0
0
0
Share
0
0
0
Flawless print.
Don't test fit it, its very tight and hard to get off (a feature in this case). Also tight for the PTFE tube, but also widening is easy not the other way around.
Share
0
0
0
awesome design, happy to try it out with the AMS attached
Share
0
0
0
Share
0
0
0
Share
0
0
0
printed perfect, think it will do the job when the spool is empty
Share
0
0
0
The reason for creating this was that the old LED cork of my bottle garden died and was ugly sticking out so far on the top (and also fiddeling around with model design in Fusion)
Cork Replacement Plug
5
18
Share
0
0
0
simple, works to check
Share
0
0
0
Passt perfekt, lediglich die Brodges im Honeycomb sind etwas unschön
Share
0
0
0
Minimal unklarer Text, in der Grafik perfekt
Share
0
0
0
Kante aufgrund der hohen Layerhöhe im ersten Layer etwas fragil. Sonst sehr gut
Share
0
0
0
No more data