Great design as usual! Magnet fit was perfect too and didn't need any glue. Thank you!

What a great design. Truly like an OEM piece. Printed in Bambu Basic Dark Gray PLA which is very close to the buffer original color. Haven't dabbled in TPU yet as I recently got the printer so I cut up some backing of little rubber feet I've been using on household prints to achieve the same effect. I also ended up using BT3 Socket Head Cap Self Tapping Screws, 25mm from the Bambu store to secure the buffer to the bracket as the original screws didn't want to grab as well as I liked. Would give 6 stars if I could!

Great design, truly pits like an OEM piece. I think this will also solve the ~1% of purges that don't go down the chute. Printed a PLA test of the V3 Extreme cut, then Sunlu Matte HS PETG on my carbon look plate. Thank you!

Worked great and great design! They were definitely quite tight and was having a heck of a time, but little dab of superlube that I use on my Z-axis lead screws and they popped right in. I ended up only trimming about 5mm off my tube as the very front left location I didn't want to push it and seems fine at the back right location. Printed in Inland gray PETG.