Very nice print. My only real nitpick is the choice to split the pattern between the base and body; could have just made the lid like 2 mm larger and it wouldn’t have had to split the “L”’s. and it would be nice to have an option to print the lid face down so you wouldn’t waste as much filaments on supports, but I guess you would have to lose the logos on the lid. again those are just nitpicks. Again, very nice print and had no issues printing.

Love this little guy. I had stringing issues with the handles on both of the prints I did, So I found and updated handle file which came out great. I originally printed it for my nephew, but loved it so much I printed one for me too. Also I guess the tail needs to be glued on which I haven’t done yet.

used the AMS 1 mounts for the top of the stacker on the left. Love the look and sturdiness of these. I printed with Bambu PLA-CF and I had only minor issues (likely my fault for not drying the filament enough). This did require some filing in the connection slots, but other than that it was easy to assemble and have to reiterate it looks great.

this took me way longer to figure out how to put the stand in the plate than it should have, but the print is nice.

Came out great with this red Bambu PLA Silk (i think my wife ordered it) I think there may still be a support in the bottom, but scared to remove it atm. Will reevaluate in the morning.

print quality was great. design is clean. I have 2 of them in my office now. pretty sure the lines in the base are from me having my garage open will printing and it was 28 F outside.

The design is nice and the piece is solid and the camera fits securely inside. I’m very new to printing so I’m not sure if the minor imperfection was an issue on my end. This print was done on my H2D with very little filament left on the spool.

Clean lines. Easy print.

Detail and lines came out very clean. I wish the top snapped or held in to place without requiring glue, but that’s just a nitpick.