Soeren

Roller Coaster Wheel Stand

Ikea Eket Gridfinity Spacers

Ikea Eket Gridfinity Base Plate

Great Model, really well designed. I am using Bambu Lab PLA for all except white (which is Sunlu) and the Tires (which is Eryone TPU). Sadly I did not have enough blue filament, so i had to print the side pieces in black which doesn't look to bad either.

 However here are some things to consider

1. Don't use Rims of another Model, for example this BMW has smaller ones than the Supra
2. Don't use too much Infill, I used 15% infill with my 2000 RPM motors (which are not recommended but work) and that works good enough but struggles sometimes, if I was to print it again i would use 7-8%
3. Make sure you have all Parts; I forgot the Side Badges at first but now added them
4. Use an Adhesive Tape (like Tixo) on the Logo to make it easier to install (not to permanently install it)

One thing I would love changed on this Model are the Logos, a alignment / installation pin (or similar) would be great. Also, a license plate for the back would be very cool :)