Worked out great and added a little hook for a speaker as well!

turned out really well!

the existing hardware didn't quite reach due to the depth of the switch, a bit of double sided tape seems to have done the trick!

it would be better to add a little divot and pin to lock the hook in place, had an issue with it being a little too flexible if caught on anything. fit the medallion well though!

turned out really awesome and a bit bigger than I expected (they were selling 3d prints in the gift shop that weren't as good as this print!) generic marble PLA worked nicely for this. Added a euro for scale

turned out really well using some generic gold filament, did a bit of touching up using a gold sharpie for a bit of accent colors.

This print turned out really cool! I may attempt adding multicolor instead of painted or adding ribbon

turned out awesome!

similar issues with needed to trim some off one of the top pieces to get it to assemble and also didn't realized the difficulty working with such tiny magnets

printed great and was a perfect fit, had a couple issues with other frames so was grateful for this one!