a great project that works as it should, great profiles and super easy to assemble. 👍👍

👍👍 prints well, and works well. thanks

Great fit and finish. no issues printing the round version. printed 2 sets. thanks 🙏

they all came out great 👍 👍 thanks

2nd to largest fit the best for me. thanks for all the options. 👍👍

works great and keeps the tube from rubbing and leaving teflon on the glass. thanks 🙏👍👍

prints good 👍👍Works as it should and finally found a good instance to use one of those stickers that came with the printer lol 😂

glue works a lot better than the snap in….

👍👍

👍👍

👍👍

👍👍

👍👍 PETG and fits great

👍👍

printed well but the supports held on like a mofo. tabs on the inside would help to hold it together instead of needing to glue it. regardless my gf’s son liked it so 👍👍

works good. don’t mind the a1 nub that got ripped off and missing lol 😂

Awesome project and great profiles just needs to be thicker to fill the gap more and then bottom support at current length would fit better under the AMS. 👍👍

great profiles 👍 no problems

absolutely love the design and functionality. will be getting a 2nd AMS 2 pro next month so that’s what prompted me to just go ahead and print this. 👍👍⭐️⭐️⭐️⭐️⭐️ Thanks for the amazing project! The 5 section mounts fit but could be a little thicker as there is a pretty large gap that may put more stress on the bearing rods that may lead to failure. I’d also feel more confident if the lip under the AMS went further under the AMS as it’s riding on a few mms on both sides as you can see in pics.

Works great but it was late and I had a total brain fart… thought it would not fit with my poop chute mod so I decided I had to cut it a bit to fit but ended up just moving the hub up a little higher 🤷. it’s in the rear out of sight so no complaints and not about to reprint it over that. 👍👍⭐️⭐️⭐️⭐️⭐️