Great for that spring time mood. Print was easy and didn't use much filament for something of this size.

I've printed a forest of these. I used matte green for the tops and they look great. Love that they convert to dead trees or bushes.

I'm always running out of doors so a 6 pack was great. I reoriented them to print standing and they came out nice.

Worked good as a test run!

Printed the body in Bambu Matte Charcoal and the accents in Sunlu Silk Copper. I printed the top on a smooth build plate to keep it from being too textured. I think it came out really nice.

Printed in matte charcoal. I changed the bottom layer fill pattern to add a little character.

I didn't have beige for the face so I used Matte Desert Tan, I'm happy with how it cane out. If I print another one I'll tweak some support settings to make them a little easier to remove.

I printed it in Nardo Grey Matte PLA and it came out really nice. Supports were not bad to remove even the ones under his cloak.

Easy print and turned out really nice!

Printed as a gift and it came out very nice. I used Bambu Brown PLA.

Worked great. If I run across some stick on foam pads to give it a little more traction from sliding I think it will work even better.

I printed a few of these in color shift silk PLA for gifts. They came out nice after I played with the settings because the filament was picky and wanted to string.

Design turned out really nice with the color shift silk PLA. The filament itself was a bit picky with settings.

Printed nice and seems fairly accurate. I only knocked off a star because I had to read through the comments to understand which line went with which label.