Search models, users, collections, and posts
Bio
Good to see you again people.
I want to try to upload as many Bricks for Construction Toys as i can and want, because I like to make them all in a bigger size so it´s more handy.
I hope you loke my work and want to have much feedback.
Other than my first Account I want only to upload the parts because the Sets as whole ones are not good printable.
Achievements
MakerWorld Guardian
This badge has expired
Sehr schönes Profil es hat sehr gut funktioniert, allerdings hätte ich mir gewünscht vielleicht Baum Supports zu verwenden, da es so sehr schwer war die Supports zu entfernen. Der Restliche Druck war sehr schön. Dabei sollte erwähnt werden, dass kein PETG für die Supports genutzt wurde, da kein AMS vorhanden ist.
Share
0
0
0
Ich habe es entgegen dem Profil mit PLA gedruckt, das war allerdings kein Problem, auch wenn ich bezüglich der Standfüße nahezu einen Herzinfakt bekommen habe. Es hat jedoch sehr gut funktioniert.
Share
0
0
0
Due to the large surface area being printed, there was some slight warping. Other than that, the design doesn’t quite match the original. However, it prints well and relatively quickly.
Share
0
0
0
Really awesome print profile! I haven’t printed below 0.2 mm with my A1 so far, since it significantly increases print time — but for this print, it's definitely recommended. It really shows off the impressive print quality of the printer even more. Highly recommended!
Share
0
0
0
Very good, slight shifting in the layers, probably due to excessive speed. Otherwise very good — it also clicks nicely into the holder with the two pins.
Share
0
0
0
Slightly oversized cap, otherwise highly recommended.
Share
0
0
0
No more data