Great print and looks good. I would only suggest something like a dovetail joint instead of the dowels. It will be great if its never moved out of the tool box, but not to move around.

This was great printed just like it looks on the picture with a snug fit for all of them. Can I suggest making one for the 3/8 ratchet set.

Printed this SAE model and the METRIC model, they both came out great. I can now keep all 3 sets Deep, Semi Deep, and Shallow sets in one tray taking less space in my box while looking great.

The print was great, came out very well. I would suggest a dovetail joint instead of a dowel. I can now have Deed, Semi deep and Shallow Icon sockets all in one tray. over all great print.

printed out well, looks great. Markers fit perfectly.

The print printed out well and looked great. Only problem that I have is that I cannot fit the charger in the whole. Sanding will be required. If it helps, my charger measures: 55.94mm total outer diameter.

I printed this and it looks great 👌. I do have some feedback, perhaps two small criticisms. 1.) For my print, the 3.0, 4.0 & 6.0 batteries fit in too tight, and it makes it very difficult to remove the tool out. I haven't tried it with the 5.0 HO yet but suspect the same result. Maybe the compartment for the battery needs to be a bit less tight? 2.) In general, it is bit difficult to remove the impact out of its designed spot, specially if any of the bigger batteries are attached. I believe that it needs somethig like finger cut out to be able to grip the tool on the left side by the trigger area. Aside from that, the print is great.