Looked great and worked perfectly for about 2 minutes, until the handle sheared off.

Printed perfectly in PETG, but it’s a little too flexible to be usable.

Broke the first one trying to get the cheek pieces in. So I used a heat gun to warm up the second one, and was able to insert them without an issue.

Printed perfectly but I neglected to measure my door frame trim beforehand, and it doesn’t fit. So I can’t attest to the functionality.

Some stringing with the supports under the cloak. They come dislodged from the base and make a real mess.

The supports under his butt disconnected from the base and caused it be super stringy for the first couple of layer. So now you can see the infill. But you have to pick him up and look up from the back. So not a real problem and I still love him.