nice print. not super clean. got soke spaghetti at the front tip, but after cleaning everything it came out good

this is an awesome dice tower. thank you so much. super easy and clean to print and set up. two suggestons if you revisit the profile: I don’t think the details on the door do all that much for it and they are flimsy. i would just take them out o the print altogether to make it cleaner. also, the pegs on the base trays, i would maybe reduce them to 95% to make them fit a bit better. though it currently fits well

lower part of the staff is very thin and breaks easily while removing supports and strangely enough there is a right sleeve and hand on Mary but no right arm. that makes it strange

lots of spaghetti on the back

it’s fun and prints well but you have to have some imagination to actually hear a melody

great piece. thanks. prints great

very nice. it prints great

very cute figure that orints clean and super easy

awesome work. great detail

absolutely adore these. printed 2 and they came out great even though i was using an old filament

very good details even though I printed it in single colour (to paint). know that the print will pause with the suggested layer changes, so if you are printing in only one colour remember to unpause it in those layer changes

tough nifty suports. but all in all pretty satisfied

tough nifty little suports in the base. but all in all pretty satisfied

nice blueberries to use in woodcraft bg. has some tough supports/raft but can be cleaned up nicely

nice sturdy and clean print. like it a lot

nice small size very clean

great print with nice details but so many supports that are tough to remove it broke some small pieces

excellent print. very clean without any supports. tops flow really smooth

it prints amazingly well. no supports. very clean