Great print. Cleanest and most satisfying support removal I've ever had, want to know how they were set up. Elastic needs to be strong and shorter than imagined to work well and close fully. Single matte pla filament on ps1 then painted (be careful as thick paint can hinder slide due to nice tolerances). Make sure to seat the slide elements fully into the rear block, as think I didn't and slide didn't pull back enough to engage the notch to hold it back, needing a slight break and rebuild.

Prints clean and clips on easily. Back spool needs to sit further out on arm to not rub against it. Haven't printed with it yet to test, but can't see it being an issue.

Amazing print in place with the back cover only used to hide the internals. My first print after the bambu scrapper and was very clean. Great tolerances and nice to see whats possible with print in place switches and springs. Very tactile and satisfying o play with. P1S with Bambu Basic PLA

Works great and clean profile with no modding. P1S with Bambu Matt PLA 0.4mm nozzle