Search models, users, collections, and posts
paper cutter
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
2.7 h
2 plates
Open in Bambu Studio
Boost
81
196
2
5
84
34
Released
Description
I made a paper cutter ,it used for cutting paper and photograph (width ≤150mm) .
installation instruction is shown in the picture.
special tips:
I need a wallpaper blade, and break off two parts with plier (see picture. ) after inserting blade.( Be careful your hand)
This model was printed using PLA. (fill in 10%，using a lower layer hight (0.15/0.2mm)，no support)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)