Search models, users, collections, and posts
Arrow Stand
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
6.5 h
4 plates
Maxed(ish) out height for H2 printers
7.6 h
4 plates
Open in Bambu Studio
Boost
282
851
72
86
729
533
Released
Description
Arrow stand to hold your arrows while you're shooting.
I designed this to hold my arrows while I'm shooting in the garage. It'll easily hold about a dozen arrows. Colours are optional. Top hexagon is optional, just adds a bit of interest. For the legs you could add adaptive layer height to make the top layer smoother. As it is, you get a bit of a stepping effect but it looks good.
Hopefully easy enough to figure out how it all goes together, everything is push fit so the tolerances are quite tight. The tricky part is sliding the legs on. Make sure you align the leg with the base as shown in the photo, the dovetail joints will form a perfect arc and slide together.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (72)